Eagle Radio - The Station that Loves Surrey and Hampshire - News - Fire at Aldershot Westgate Shopping Centre: There was a fire at the new Westgate shopping centre in Aldershot this morning.2 crews from Rushmoor were called to the building just after 8:30. There was a large amount of smoke caused by a 500-litre tar boiler.
When crews arrived, the boiler had burnt itself out.Firefighters managed to put the blaze out with 2 litres of foam jet by nine-thirty.
Visit safety photos
Stories of workers who went to work with every intention of going home, but never did.
Thursday, 4 October 2012
Excavator driver sentenced under section 7 after worker severely injured on first day
Excavator driver sentenced after worker severely injured on first day: A Nottinghamshire demolition company and one of its employees have appeared in court after a worker suffered severe injuries when he was hit by a falling excavator bucket on his first day on site.
Labourer James Wilson, of Misterton, was working for Bloom Plant Ltd on a demolition site on Kilton Road, Worksop, on 10 January 2011.
Excavator driver Paul Batty, who was also employed by Bloom Plant Ltd, was re-attaching the four tonne excavator bucket to the boom of his machine when it fell and slid down a pile of rubble, landing on Mr Wilson and leaving him with major crush injuries.
Visit safety photos
Labourer James Wilson, of Misterton, was working for Bloom Plant Ltd on a demolition site on Kilton Road, Worksop, on 10 January 2011.
Excavator driver Paul Batty, who was also employed by Bloom Plant Ltd, was re-attaching the four tonne excavator bucket to the boom of his machine when it fell and slid down a pile of rubble, landing on Mr Wilson and leaving him with major crush injuries.
Visit safety photos
Solvents With Safety Ltd - prosecuted for decanting failures and huge fire
Solvent company prosecuted for decanting failures: A Doncaster solvent company has been fined after an unsafe decanting operation caused a huge fire that engulfed its Harworth base.
Employees were transferring highly flammable toluene from a bulk container into a smaller drum ahead of the incident at Solvents With Safety Ltd at Plumtree Farm Industrial Estate on 16 June 2010.
They were attempting to fill the drum using a pipe from the container, however the pipe they used was too short. It meant dropping the liquid from the pipe into the drum, a process called 'splash filling' that is known to generate static electricity - a potential ignition source.
Doncaster Magistrates' Court heard (3 October) that the flash point of toluene is just 4 degrees. So on a "hot" June evening when the process took place, the toluene would have a flammable vapour over its surface.
The build up of static electricity in the drum is thought to have ignited the vapour and sparked a fire that quickly took hold and spread to other containers of flammable and dangerous solvent mixtures at the site, some of which exploded.
Seven workers were present at the time, but all managed to escape unharmed after a quick-thinking supervisor ordered them to evacuate the site and called the emergency services. The initial blaze was described as escalating to a raging inferno within minutes.
An investigation by the Health and Safety Executive (HSE) found the 'splash fill' method was wholly inappropriate and posed a clear risk that wasn't properly assessed.
Worker safety was further compromised by the fact that the pipe used to fill the container wasn't earthed, and because the personal protective equipment worn by the workers wasn't anti-static and was therefore unsuitable.
The court also heard that HSE had twice written to Solvents With Safety, in May 2006 and December 2007, to warn of the dangers of splash filling containers.
The company pleaded guilty to breaching Reg 6(1) of the Dangerous Substances and Explosive Atmospheres Regulations 2002 and was fined £20,000 and ordered to pay £6,860 in costs.
Visit safety photos
Employees were transferring highly flammable toluene from a bulk container into a smaller drum ahead of the incident at Solvents With Safety Ltd at Plumtree Farm Industrial Estate on 16 June 2010.
They were attempting to fill the drum using a pipe from the container, however the pipe they used was too short. It meant dropping the liquid from the pipe into the drum, a process called 'splash filling' that is known to generate static electricity - a potential ignition source.
Doncaster Magistrates' Court heard (3 October) that the flash point of toluene is just 4 degrees. So on a "hot" June evening when the process took place, the toluene would have a flammable vapour over its surface.
The build up of static electricity in the drum is thought to have ignited the vapour and sparked a fire that quickly took hold and spread to other containers of flammable and dangerous solvent mixtures at the site, some of which exploded.
Seven workers were present at the time, but all managed to escape unharmed after a quick-thinking supervisor ordered them to evacuate the site and called the emergency services. The initial blaze was described as escalating to a raging inferno within minutes.
An investigation by the Health and Safety Executive (HSE) found the 'splash fill' method was wholly inappropriate and posed a clear risk that wasn't properly assessed.
Worker safety was further compromised by the fact that the pipe used to fill the container wasn't earthed, and because the personal protective equipment worn by the workers wasn't anti-static and was therefore unsuitable.
The court also heard that HSE had twice written to Solvents With Safety, in May 2006 and December 2007, to warn of the dangers of splash filling containers.
The company pleaded guilty to breaching Reg 6(1) of the Dangerous Substances and Explosive Atmospheres Regulations 2002 and was fined £20,000 and ordered to pay £6,860 in costs.
Visit safety photos
Parkstone Construction Ltd fined after worker run over by digger
Firm fined after worker run over by digger: A construction company has been fined after a worker suffered multiple injuries when he was run over by a seven tonne digger in Mansfield.
Michael Tomlinson, from Birmingham, suffered multiple injuries including a ruptured bladder, and fractured wrist, in the incident at a construction site on Jubilee Way South, on 8 November 2010.
Mansfield Magistrates' Court heard today (3 October) that he was working as a groundworker for Birmingham-based Parkstone Construction Ltd to prepare the foundations for a supermarket.
A reversing digger struck Mr Tomlinson after the driver failed to notice him behind the vehicle. He took the full impact of the tracks as they knocked him to the ground and crushed him underneath.
An investigation by the Health and Safety Executive (HSE) found that Parkstone Construction Ltd had failed to ensure that workers were safely segregated from moving vehicles while work was being carried out.
The company, of Stonebridge Road, Coleshill, Birmingham, pleaded guilty to breaching Section 3 (1) of the Health and Safety at Work etc Act 1974 and was fined £15,000 with costs of £6,447.
Visit safety photos
Michael Tomlinson, from Birmingham, suffered multiple injuries including a ruptured bladder, and fractured wrist, in the incident at a construction site on Jubilee Way South, on 8 November 2010.
Mansfield Magistrates' Court heard today (3 October) that he was working as a groundworker for Birmingham-based Parkstone Construction Ltd to prepare the foundations for a supermarket.
A reversing digger struck Mr Tomlinson after the driver failed to notice him behind the vehicle. He took the full impact of the tracks as they knocked him to the ground and crushed him underneath.
An investigation by the Health and Safety Executive (HSE) found that Parkstone Construction Ltd had failed to ensure that workers were safely segregated from moving vehicles while work was being carried out.
The company, of Stonebridge Road, Coleshill, Birmingham, pleaded guilty to breaching Section 3 (1) of the Health and Safety at Work etc Act 1974 and was fined £15,000 with costs of £6,447.
Visit safety photos
Renewables Obligation: Government backtracks on proposals to exclude small-scale projects from scheme
Renewables Obligation: Government backtracks on proposals to exclude small-scale projects from scheme: The Government will not be excluding new small scale commercial renewable electricity generation projects from its Renewables Obligation (RO) financial support programme, Energy Minister Greg Barker has announced.0
It had previously proposed excluding new solar, anaerobic digestion, onshore wind and hydro power installations with a generating capacity of between 50kW and 5MW from the RO as of April next year. The changes, contained in a review of the Government's support for renewable published in July, would have seen the RO limited to projects over 5MW with smaller projects instead eligible for the Government's feed-in tariff (FiT) scheme.
Visit safety photos
It had previously proposed excluding new solar, anaerobic digestion, onshore wind and hydro power installations with a generating capacity of between 50kW and 5MW from the RO as of April next year. The changes, contained in a review of the Government's support for renewable published in July, would have seen the RO limited to projects over 5MW with smaller projects instead eligible for the Government's feed-in tariff (FiT) scheme.
Visit safety photos
Subscribe to:
Posts (Atom)

